DEFINITIONCement based, single component, fibrous, It is a polymer reinforced thick/fine aggregate surface filling and leveling mortar.

APPLICATION AREAS

Cement plastered ceiling, It is used for filling large gaps and cracks on wall and floor surfaces. Especially for repairing the surfaces of exposed concrete and reinforced concrete building elements . and is applied as a thin layer to eliminate mold defects. Inrestoration processes, ceramics, granite and natural stone slabs and similar coatings ideal for achieving a clean surface underneath.

APPLICATION
Make sure that the ambient temperature is between +5 °C and +35 °C during application. Do not apply on surfaces that are frozen, melting or in danger of freezing within 24 hours. Do not apply under direct sun or strong wind.

• Application thickness: 2 cm.
• Service opening time: approx. 24 hours (+20°C).
• Full curing time: 28 days (+20°C)

Pour 25 kg Fixser Thick/Fine Repair Mortar into 4.5-5.5 liters of clean water and mix with a low speed mixer until a homogenous mixture without lumps is obtained. Allow the mixture to rest for 5 minutes before application and mix again to make it ready for use. Apply the mortar on the concrete surface with a steel trowel. If more than one coat is to be applied, wait 3 hours between coats and moisten the surface before applying the next coat. After at least 2 hours, the surface should be troweled and a plastic trowel or damp sponge should be used for very smooth surfaces. The surface should be moisturized for 2-3 days after application.

WARNINGS
No material (lime, cement, gypsum, etc.) should be added to the prepared mortar. Expired mortars should not be mixed with water or dry mortar and used again. Do not apply on very hot or frozen surfaces exposed to the sun for a long time. Do not exceedthe specified application surface and instructions for use. Do not inhale, in case of eye contact, rinse with plenty of water and consult a doctor if necessary. Since it is a cement based material , gloves should be worn during application. The packaged product should not be stored in humid environments.

CONSUMPTION1.6-1.8 kg /m² (for 1 mm coat thickness )

HEALTH and SAFETY

Avoidskin and eye contact. Gloves must be worn during storage and application.